2010 Chevrolet Cobalt Owner's Manual - Page 228

To Mute a call 1. Press b g . The system responds with "Ready" followed by a tone. 2. Say "Mute Call". The system responds with "Call muted". To Transfer Audio to the In-Vehicle Bluetooth System The cellular phone must be paired and connected with the Bluetooth system before a call can be transferred. The connection process can take up to two minutes after the key is turned to the ON/RUN or ACC/ ACCESSORY position. During a call with the audio on the cell phone, press b g for more than two seconds. The audio switches from the cell phone to the vehicle. To Cancel Mute 1. Press b g . The system responds with "Ready" followed by a tone. 2. After the tone, say "Mute Call". The system responds with "Resuming call". Voice Pass-Thru Voice Pass-Thru allows access to the voice recognition commands on the cell phone. See the cell phone manufacturers user guide to see if the cell phone supports this feature. This feature can be used to verbally access contacts stored in the cell phone. 1. Press and hold b g for two seconds. The system responds with "Ready" followed by a tone. 2. Say "Bluetooth". The system responds with "Bluetooth ready" followed by a tone. 3. Say "Voice". The system responds with "OK, accessing ". . Transferring a Call Audio can be transferred between the in-vehicle Bluetooth system and the cell phone. To Transfer Audio to the Cell Phone During a call with the audio in the vehicle: 1. Press b g . The system responds with "Ready" followed by a tone. 2. Say "Transfer Call." The system responds with "Transferring call" and the audio will switch from the vehicle to the cell phone. The cell phone's normal prompt messages will go through its cycle according to the phone's operating instructions. 4-82