2010 Chevrolet Traverse Owner's Manual - Page 37

Keys, Doors and Windows 3. Insert the new battery, positive side facing down. Replace with a CR2032 or equivalent battery. 4. Snap the transmitter back together. If the vehicle has the remote start feature, the RKE transmitter functions have an increased range of operation. However, the range may be less while the vehicle is running. There are other conditions which can affect the performance of the transmitter, see Remote Keyless Entry (RKE) System on page 2‑2 for additional information. 2-5 Remote Vehicle Start This vehicle may have a remote starting feature that starts the engine from outside of the vehicle. / (Remote Start): This button is located on the RKE transmitter if the vehicle has remote start. Laws in some communities may restrict the use of remote starters. For example, some laws may require a person using the remote start to have the vehicle in view when doing so. Check local regulations for any requirements on remote starting of vehicles. Do not use the remote start feature if the vehicle is low on fuel. The vehicle could run out of fuel. When the vehicle starts the parking lamps will turn on and remain on as long as the engine is running. The doors will be locked and the climate control system will operate automatically if the vehicle has the automatic system, or at the same setting as when the vehicle was last turned off. If the vehicle has an automatic climate control system and heated seats, the heated seats turn on during colder outside temperatures and shut off when the key is turned to ON/RUN. See Heated Front Seats on page 3‑9 or Heated and Ventilated Front Seats on page 3‑10 for more information. The rear window defogger and heated mirrors, if the vehicle has them, turn on during colder outside temperatures and turn off when the key is turned to ON/RUN. Starting the Engine Using Remote Start To start the vehicle: 1. Aim the RKE transmitter at the vehicle. 2. Press Q on the RKE transmitter. 3. Immediately after completing Step 2, press and hold / until the parking lamps flash. If the vehicle's lights can not be seen, press and hold / for at least four seconds.