2010 Chevrolet Traverse Owner's Manual - Page 38
2010 Chevrolet Traverse Manual
Page 38 highlights
2-6 Keys, Doors and Windows been running for five minutes, 10 minutes are added, allowing the engine to run for a total of 15 minutes. A maximum of two remote starts or remote start attempts are allowed between ignition cycles. After the vehicle's engine has been started two times using the remote start button, the ignition must be turned on and then back off before the remote start procedure can be used again. After entering the vehicle during a remote start, insert and turn the key to the ON/RUN position to drive the vehicle. If the vehicle is left running it automatically shuts off after 10 minutes unless a time extension has been done. Conditions in Which the Remote Start Will Not Work The vehicle cannot be started using the remote start feature if the key is in the ignition, the hood is open, or if there is an emission control system malfunction. The engine turns off during a remote start if the coolant temperature gets too high or if the oil pressure gets low. Vehicles that have the remote vehicle start feature are shipped from the factory with the remote vehicle start system enabled. The system may be enabled or disabled through the DIC if the vehicle has DIC buttons. See "REMOTE START" under Vehicle Personalization (With DIC Buttons) on page 5‑40 for additional information. If the vehicle does not have DIC buttons, see your dealer/ retailer to enable or disable the remote start system. Extending Engine Run Time To extend the engine run time by 10 minutes, repeat Steps 1 though 3 while the engine is still running. The engine run time can only be extended if it is the first remote start since the vehicle has been driven. Remote start can be extended one time. If the remote start procedure is used again before the first 10 minute time frame has ended, the first 10 minutes will immediately expire and the second 10 minute time frame will start. For example, if the lock button and then the remote start buttons are pressed again after the vehicle has Shutting the Engine Off After a Remote Start To manually shut off a remote start: . Aim the RKE transmitter at the vehicle and press / until the parking lamps turn off. Turn on the hazard warning flashers. Turn the ignition switch on and then off. . .