2005 Chrysler Pacifica Owner Manual Touring - Page 127

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 127 If you live in Canada or you are having difficulties programming a gate operator by using the ЉProgrammingЉ procedures (regardless of where you live), replace ؆Programming HomeLink؆ step 3 with the following: NOTE: If programming a garage door opener or gate operator, it is advised to unplug the device during the ЉcyclingЉ process to prevent possible overheating. 3. Continue to press and hold the HomeLink button while you press and release every two seconds (ЉcycleЉ) your hand-held transmitter until the frequency signal has successfully been accepted by HomeLink. (The indicator light will flash slowly and then rapidly.) Proceed with ЉProgrammingЉ step four to complete. Using HomeLink To operate, simply press and release the programmed HomeLink button. Activation will now occur for the trained device (i.e. garage door opener, gate operator, security system, entry door lock, home/office lighting, etc.). For convenience, the hand-held transmitter of the device may also be used at any time. In the event that there are still programming difficulties or questions, contact HomeLink at: www.homelink.com or 1-800-3553515. Erasing HomeLink Buttons To erase programming from the three buttons (individual buttons cannot be erased but can be ЉreprogrammedЉ note below), follow the step noted: • Press and hold the two outer HomeLink buttons until the indicator light begins to flash-after 20 seconds. Release both buttons. Do not hold for longer that 30 seconds. HomeLink is now in the train (or learning) mode and can be programmed at any time beginning with ЉProgrammingЉ - step 2. 3