2006 Chrysler 300 Owner Manual - Page 126
2006 Chrysler 300 Manual
Page 126 highlights
126 UNDERSTANDING THE FEATURES OF YOUR VEHICLE door opener may have a multiple security code system (rolling code system). Please proceed to steps 6-8 to complete the programming of a rolling code equipped device (most common garage door openers require this step. 6. At the garage door opener receiver (motor-head unit) in the garage, locate the ЉlearnЉ or ЉsmartЉ button. This can usually be found where the hanging antenna wire is attached to the motor-head unit. 7. Firmly press and release the ЉlearnЉ or ЉsmartЉ button. (The name and color of the button may vary by manufacturer.) NOTE: There are 30 seconds in which to initiate step eight. 8. Return to the vehicle and firmly press, hold for two seconds and release the programmed HomeLink button. Repeat the ؆press/hold/release؆ sequence a second time, and, depending on the brand of the garage door opener (or other rolling code equipped device), repeat this sequence a third time to complete the programming. HomeLink should now activate your rolling code equipped device. NOTE: To program the remaining two HomeLink buttons, begin with ЉProgrammingЉ step two. Do not repeat step one. For questions or comments, please contact HomeLink at www.homelink.com or 1-800-355-3515. Canadian Programming/Gate Programming Canadian radio-frequency laws require transmitter signals to Љtime-outЉ (or quit) after several seconds of transmission which may not be long enough for HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to Љtime-outЉ in the same manner. If you live in Canada or you are having difficulties programming a gate operator by using the ЉProgrammingЉ procedures (regardless of where you live), replace ؆Programming HomeLink؆ step 3 with the following: NOTE: If programming a garage door opener or gate operator, it is advised to unplug the device during the ЉcyclingЉ process to prevent possible overheating.