2008 Chrysler Aspen Owner Manual - Page 32
2008 Chrysler Aspen Manual
Page 32 highlights
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 31 Automatic Door Locks If this feature is enabled, your door locks will lock automatically when the vehicle's speed exceeds 15 mph (24 km/h). Automatic Door Lock Programming This feature is enabled when your vehicle is shipped from the assembly plant and can be disabled by following these procedures: • For vehicles equipped with the Electronic Vehicle Information Center (EVIC), refer to "Personal Settings (Customer Programmable Features)" under "Overhead Console with Electronic Vehicle Information Center (EVIC) - If Equipped" in Section 3. • For vehicles not equipped with the EVIC: 1. Enter your vehicle and close all doors. 2. Fasten your seat belt. Fastening the seat belt will cancel any chiming that may confuse you during this programming procedure. 3. Place the key into the ignition. 4. Within 10 seconds, cycle the key from the LOCK position to the ON position a minimum of four times, ending in the LOCK position (do not start the engine). 5. Within 30 seconds, press the driver's door lock switch in the LOCK direction. 6. A single chime will be heard to indicate the feature has been disabled. 7. To reactivate this feature, repeat the above steps. 8. If a chime is not heard, the program mode was canceled before the feature could be disabled. If necessary, repeat the above procedure. 2