2009 Dodge Caliber Owner Manual SRT4 - Page 316

314 WHAT TO DO IN EMERGENCIES (D) After Injecting TIREFIT Sealant: 1. Allow the air pump to inflate the tire to the pressure indicated on the tire pressure label on the driver-side latch pillar. Check the pressure in the tire by looking at the Pressure Gauge (2). • If the tire inflates to at least 26 psi (1.8 bar) within 15 minutes, proceed to Step 2 of this procedure. • If tire fails to inflate to 26 psi (1.8 bar) within 15 minutes, perform the procedure steps described under "(G) Distributing TIREFIT Sealant to Better Enable Tire Inflation." 2. Press the Air Pump Power Button (3) to turn OFF the TIREFIT kit. 3. Remove the Speed Limit sticker from the top of the Sealant Bottle (1) and place the sticker on the steering wheel. 4. Disconnect the Clear Sealant Hose (7) from the valve stem, reinstall the Yellow Cap on the fitting at the end of the hose, and place the TIREFIT kit in the vehicle. CAUTION! Failure to reinstall the Yellow Cap on the fitting at the end of the Clear Sealant Hose (7) can result in sealant contacting your skin, clothing, and the vehicle's interior. It can also result in sealant contacting internal TIREFIT kit components causing permanent damage to the kit. (E) Securing TIREFIT Sealant in the Tire Drive the vehicle for approximately 5 miles (8 km) to ensure distribution of the TIREFIT Sealant within the tire.