2010 Dodge Ram 1500 Regular Cab User Guide - Page 20
2010 Dodge Ram 1500 Regular Cab Manual
Page 20 highlights
GETTING STARTED PROGRAMMABLE FEATURES Electronic Vehicle Information Center (EVIC) - If Equipped • The EVIC can be used to program the following Personal Settings. Press the UP or DOWN button until SYSTEM SETUP displays, then press the SELECT button . Scroll through the settings using the UP or DOWN button. Press the SELECT button to change the setting. • Select Language • Nav-Turn By Turn • Park Assist System • Auto Door Locks • Auto Unlock Doors • Remote Unlock Sequence • RKE Linked To Memory • Remote Start Comfort Sys. • Horn With Remote Start • Horn With Remote Lock • Flash Lamps With Lock • Headlamp Off Delay • Headlamps With Wipers • Automatic High Beams - If Equipped • Wiper Mode - If Equipped • Easy Exit Seat - If Equipped • Tilt Mirror In Reverse • Key-Off Power Delay • Illuminated Approach • Hill Start Assist (HSA) • Display Fuel Saver - If Equipped • Compass Variance • Calibrate Compass Key Fob Programmable Features • The following features may also be programmed by using the Key Fob transmitter or the ignition switch and driver's door lock switch. NOTE: Pressing the LOCK button while you are inside the vehicle will activate the Vehicle Security Alarm. Opening a door with the Vehicle Security Alarm activated will cause the alarm to sound. Press the UNLOCK button to deactivate the Vehicle Security Alarm. Unlock On First Press • To unlock either the driver's side, or all doors, on the first press of the UNLOCK button: • Press and hold the LOCK button for at least 4 seconds, but no longer than 10 seconds. Then, press and hold the UNLOCK button while still holding the LOCK button. • Release both buttons at the same time. Auto Unlock Doors On Exit • To have all of the vehicle doors unlock when any door is opened: • Enter your vehicle, close all the doors and fasten your seat belt. • Within 15 seconds, cycle the ignition switch from the OFF position to the ON position a minimum of four times, ending in the OFF position (do not start the engine). • Within 30 seconds, press the driver's door lock switch in the UNLOCK direction. A single chime will indicate that programming is complete. 18