2011 Dodge Dakota Crew Cab Owner Manual - Page 31
2011 Dodge Dakota Crew Cab Manual
Page 31 highlights
30 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 3. Place the key into the ignition. 4. Within 10 seconds, cycle the key from the position to the ON/RUN position and back to position, a minimum of four times; ending in the position. (Do not start the engine.) 5. Within 30 seconds, press the driver's door switch in the LOCK direction. has been shifted into the PARK position after the vehicle has been driven (shifted out of PARK and the doors LOCK closed). LOCK LOCK Auto Unlock Feature Programming The Customer Programming sequence to disable or enable Auto Unlock: LOCK 1. Enter your vehicle and close all the doors. 6. A single chime will be heard to indicate the feature has 2. Fasten your seat belt. (Fastening the seat belt will cancel any chiming that may be confusing during this been disabled. programming procedure.) 7. To reactivate this feature, repeat the above steps. 3. Insert the key into the ignition. 8. If a chime is not heard, program mode was canceled before the feature could be disabled. If necessary, repeat 4. Within 15 seconds, cycle the key from the LOCK position to the ON/RUN position and back to LOCK the above procedure. position, a minimum of four times; ending in the LOCK Auto Unlock On Exit Feature - If Equipped position. (Do not start the engine.) This feature unlocks all of the doors of the vehicle when any door is opened. This will occur only after the vehicle