2011 Dodge Nitro Owner Manual - Page 296
2011 Dodge Nitro Manual
Page 296 highlights
STARTING AND OPERATING 293 With Tip Start If the engine fails to start after you have followed the "Normal Starting" or "Extreme Cold Weather" procedures, it may be flooded. To clear any excess fuel, press the accelerator pedal all the way to the floor and hold it. Then, turn the ignition switch to the START position and release it as soon as the starter engages. The starter motor will disengage automatically in 10 seconds. Once this occurs, release the accelerator pedal, turn the ignition switch to the LOCK position, wait 10 to 15 seconds, then repeat the "Normal Starting" procedure. ENGINE BLOCK HEATER - IF EQUIPPED The engine block heater warms the engine, and permits quicker starts in cold weather. Connect the cord to a standard 110-115 Volt AC electrical outlet with a grounded three-wire extension cord. The engine block heater cord is found under the hood clipped to the heater line on the left side of the engine. The engine block heater must be plugged in at least one hour to have an adequate warming effect on the engine. 5 WARNING! CAUTION! To prevent damage to the starter, wait 10 to 15 seconds before trying again. After Starting The idle speed will automatically decrease as the engine warms up. Remember to disconnect the engine block heater cord before driving. Damage to the 110-115 Volt AC electrical cord could cause electrocution.