2011 Dodge Nitro Owner Manual - Page 59

56 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 5 mph (8 km/h), BeltAlert௡ will chime once and illumi- 1. With the ignition in the OFF position, buckle the nate the Seat Belt Reminder Light, then will proceed to driver's seat belt. the 96 second warning sequence. 2. Turn the ignition switch to the ON/RUN position (do The front passenger seat BeltAlert௡ is not active when the not start the engine), and wait for the Seat Belt Reminder front passenger seat is unoccupied. BeltAlert௡ may be Light to turn off. triggered when an animal or heavy object is on the front 3. Unbuckle and then re-buckle the driver's seat belt passenger seat or when the seat is folded flat (if three times, ending with the seat belt buckled. This must equipped). It is recommended that pets be restrained in be completed within 60 seconds of turning the ignition the rear seat in pet harnesses or pet carriers that are switch to the ON/RUN position. secured by seat belts, and cargo is properly stowed. 4. Turn the ignition switch to the OFF position. A single BeltAlert௡ can be enabled or disabled by your authorized chime will sound to signify that you have successfully dealer or by following these steps: completed the programming. NOTE: The following steps must occur within the first NOTE: Watch for the Seat Belt Reminder Light to turn 60 seconds of the ignition switch being cycled to the on while the seat belt retracts and turn off while reON/RUN position. Chrysler Group LLC does not recombuckling the seat belt. mend deactivating BeltAlert௡. BeltAlert௡ can be reactivated by repeating this procedure.