2008 Ford Taurus X Owner's Manual - Page 114

Driver Controls 5. Firmly press and release the "learn" or "smart" button. (The name and color of the button may vary by manufacturer.) Note: There are 30 seconds in which to initiate Step 6. 6. Return to the vehicle and firmly press, hold for two seconds and release the programmed HomeLink button. Repeat the press/hold/release sequence again and, depending on the brand of the garage door opener (or other rolling code equipped device), repeat this sequence a third time to complete the programming. HomeLink should now activate your rolling code equipped device. To program additional HomeLink buttons begin with Step 1 in the "Programming" section. For questions or comments, please contact HomeLink at www.homelink.com or 1-800-355-3515. Gate Operator & Canadian Programming During programming, your hand-held transmitter may automatically stop transmitting - not allowing enough time for HomeLink to accept the signal from the hand-held transmitter. After completing Step 1 outlined in the "Programming" section, replace Step 2 with the following: Note: If programming a garage door opener or gate operator, it is advised to unplug the device during the "cycling" process to prevent overheating. • Continue to press and hold the HomeLink button (note Step 2 in the "Programming" section) while you press and release - every two seconds ("cycle") your hand-held transmitter until the frequency signal has been accepted by the HomeLink . The indicator light will flash slowly and then rapidly after HomeLink accepts the radio frequency signal. • Proceed with Step 3 in the "Programming" section. 114 2008 Taurus X (219) Owners Guide (post-2002-fmt) USA (fus)