2011 Ford Fiesta Owner Guide 3rd Printing - Page 135

Locks and Security • • • If • the ignition is on, you shift into any gear putting the vehicle in motion, and the vehicle attains a speed greater than 12 mph (20 km/h). a door(s) is unlocked, the autolock feature will repeat when: the vehicle slows below 12 mph (20 km/h) and then attains a speed greater than 12 mph (20 km/h). Autounlock (if equipped) If the doors have been autolocked, the doors will autounlock only when: • the ignition is turned off or to accessory, • the driver door is opened within 10 minutes of the ignition being switched from on to off or accessory. Note: If you use the power door lock button to lock the doors before an autolock event, the doors will not autounlock. Deactivating/activating autolock/autounlock Note: When programming the autolock feature, carry out the following steps within 30 seconds or the procedure needs to be repeated. If the procedure needs to be repeated, wait 30 seconds between programming sessions. 1. Turn the ignition on. 2. Press the power door lock control three times. 3. Turn the ignition off. 4. Press the power door lock control three times. 5. Turn the ignition on. The module is now in programming mode. Note: A chime sounds as acknowledgement that the programming mode has been entered. The safety belt must be engaged otherwise the Belt-Minder௡ chime will take priority over other chimes. 6. Once in programming mode, the autolock or autounlock feature can be programmed independently of each other. • To program the autolock feature, press the power door lock control for greater than 2 seconds and release. Each long press of the power door lock control toggles the state of the autolocking feature between enabled and disabled. A chime sounds when the feature is enabled or disabled. 135 2011 Fiesta (fie) Owners Guide, 3rd Printing USA (fus)