2012 Ford Edge Owner Guide 1st Printing - Page 94
2012 Ford Edge Manual
Page 94 highlights
Driver Controls Note: It is the driver's responsibility to select a gap appropriate to the driving conditions. Disengaging adaptive cruise control Press the brake pedal or press CNCL to disengage the adaptive cruise control. The last set speed will be displayed with a strikethrough. Disengaging the adaptive cruise control will not erase your previous set speed. Overriding adaptive cruise control WARNING: Whenever the driver is overriding the ACC by pressing the accelerator pedal, the ACC will not automatically apply the brakes to maintain separation from any vehicle ahead. The set speed and gap distance can be overridden by pressing the accelerator pedal. When the driver is overriding ACC, the green ACC light is illuminated, and the follow vehicle is not displayed in the message center. When the accelerator is released, the ACC function will operate again and vehicle speed will decrease to the set speed, or a lower speed if following a slower vehicle. Changing the set speed There are three ways to change the set speed: • Accelerate or brake to the desired speed and press SET upward and release. • Increase or decrease the speed by holding SET upward or downward until the desired set speed is shown on the message center. The vehicle speed will gradually change to the selected speed. • Increase or decrease the speed in increments of 1 mph (2 km/h) by briefly pressing the SET upward or downward. The ACC may apply the brakes to slow the vehicle down to the new set speed. The set speed will display continuously in the message center while ACC is active. Resuming the set speed Press and release RES/CNCL. This will automatically return the vehicle to the previously set speed. The set speed will display continuously in the message center while ACC is active. Note: Resume should only be used if the driver is aware of the set speed and intends to return to it. 94 2012 Edge (edg) Owners Guide, 1st Printing USA (fus)