2012 Ford Flex Owner Guide 2nd Printing - Page 117

Driver Controls Care should be exercised in starting the engine before the liftgate is fully closed (latched). If the ignition is cycled during a liftgate power close cycle and the liftgate is 6-10 inches (15-24 cm) from being latched, the liftgate may reverse to the full open position. Verify that the gate is closed before operating or moving the vehicle, especially in an enclosure, like a garage or a parking structure. The liftgate or its components could be damaged in an enclosure, if the liftgate is open. When power operating the liftgate at temperatures below 32°F (0°C), the liftgate may stop about 5 inches (12.7 cm) from the full open position. The liftgate can be fully opened by pushing it upward to the maximum open position. The power liftgate feature can be enabled or disabled using the message center. With the control in the OFF position, power operation is disabled from the liftgate handle button and from the rear cargo area button. The integrated keyhead transmitter and instrument panel switch will still continue to operate the liftgate regardless of the position state of the message center. Refer to Message center in the Instrument Cluster chapter. To power open or close the liftgate from the instrument panel: Press the button, located on the instrument panel, once to power open or close the liftgate. To power open or close the liftgate with the integrated keyhead transmitter: twice within three Press seconds to power open or close the liftgate. Refer to Remote entry system in the Locks and Security chapter. 117 2012 Flex (471) Owners Guide, 2nd Printing USA (fus)