2012 Ford Flex Owner Guide 2nd Printing - Page 135

Locks and Security 4. Wait 10 seconds, then press the . 5. Repeat this procedure for memory 2 and another transmitter if desired. Deprogramming memory feature from the transmitter To deactivate this feature: 1. Press and hold either the 1 or 2 button on the driver's door for five seconds. A tone will be heard after 11⁄2 seconds when the memory store is done, continue to hold until a second tone is heard after five seconds. 2. Within three seconds press the . 3. Repeat this procedure for another transmitter if desired. Replacing the battery The integrated keyhead transmitter uses one coin type three-volt lithium battery CR2032 or equivalent. To replace the battery: 1. Twist a thin coin in the slot of the IKT near the key ring in order to remove the battery cover. Note: Do not wipe off any grease on the battery terminals on the back surface of the circuit board. 2. Remove the old battery. Note: Please refer to local regulations when disposing of transmitter batteries. 3. Insert the new battery. Refer to the instructions inside the IKT for the correct orientation of the battery. Press the battery down to ensure that the battery is fully seated in the battery housing cavity. 4. Snap the battery cover back onto the key. Note: Replacement of the battery will not cause the IKT to become deprogrammed from your vehicle. The IKT should operate normally after battery replacement. 135 2012 Flex (471) Owners Guide, 2nd Printing USA (fus)