2012 Ford Flex Owner Guide 2nd Printing - Page 90

Lights 3. Remove the bulb socket by turning it counterclockwise and pulling it straight out. 4. To remove the bulb, pull it straight out of the bulb socket. Install the new bulb(s) in reverse order. Replacing rear stop/tail/turn/backup and side marker lamp bulbs (non LED) The stop/tail/turn/backup and side marker lamp bulbs are located in the tail lamp assembly. Note: Your vehicle may be equipped with a stop/tail/turn and side marker lamp assemblies containing integral multiple light emitting diodes (LED). If replacement is required, see your authorized dealer. • (1) Backup lamp • (2) Stop/tail/turn signal lamp • (3) Side marker lamp • (4) Supplemental taillamp 1. Make sure the headlamp switch is in the off position and open the liftgate. 2. Remove the hex screws in the liftgate opening, then pull the lamp assembly away from the vehicle. This will disengage two snap attachments along the side of the vehicle. 3. Remove the bulb socket by rotating it counterclockwise, then pulling it out of the lamp assembly. 4. Pull the bulb straight from the socket. Install new bulb(s) in reverse order. 90 2012 Flex (471) Owners Guide, 2nd Printing USA (fus)