2012 Ford Flex Owner Guide 2nd Printing - Page 262
2012 Ford Flex Manual
Page 262 highlights
Driving experienced, SLOW DOWN. Always use caution when towing a trailer and follow the tongue weight recommendations. Refer to Trailer towing in the Tires, Wheels and Loading chapter for more information on towing a trailer with your vehicle. During trailer sway control events, the stability control light in the instrument cluster will flash momentarily. The cluster message center will also display TRAILER SWAY REDUCE SPEED. In some cases when trailer sway is detected, the vehicle speed is too high and may be at or above a speed at which trailer sway will grow continuously. This may cause the system to activate multiple times, causing a gradual reduction in speed. Disabling trailer sway control Trailer sway control can be disabled during any key cycle. To disable trailer sway control, refer to the Message center in the Instrument Cluster chapter. Note that regardless of chosen enable state, trailer sway control will be re-enabled each new key cycle. WARNING: Turning off trailer sway control increases the risk of loss of vehicle control, serious injury, or death. Ford does not recommend disabling this feature except in situations where speed reduction may be detrimental (e.g., hill climbing), the driver has significant trailer towing experience, and can control trailer sway and maintain safe operation. STEERING 3.5L EcoBoost™ engine: Your vehicle is equipped with an Electric Power Steering (EPS) system. There is no fluid reservoir to check or fill. If your vehicle loses electrical power while you are driving (or if the ignition is turned off), you can steer the vehicle manually, but it takes more effort. Extreme continuous steering may increase the effort it takes for you to steer. This occurs to prevent internal overheating and permanent damage to your steering system. If this should occur, you will neither lose the ability to steer the vehicle manually nor will it cause permanent damage. Typical steering and driving maneuvers will allow the system to cool and steering assist will return to normal. The EPS system has diagnostic checks that continuously monitor the EPS system to ensure proper operation. When a system error is detected, the following message SERVICE POWER STEERING, SERVICE POWER STEERING NOW or POWER STEERING ASSIST FAULT may display in the message center, refer to the Message center in the Instrument Cluster chapter for more information. 262 2012 Flex (471) Owners Guide, 2nd Printing USA (fus)