2013 Ford Escape Owner Manual Printing 4 - Page 240
2013 Ford Escape Manual
Page 240 highlights
Maintenance Headlamp: A B C 2 4 A B C Side marker Low beam headlamp High beam headlamp 1. 2. 3. 4. High beam headlamp: Remove the headlamp. Remove service cap. Disconnect the electrical connector. Remove bulb from the headlamp assembly by turning it counterclockwise, then pull it straight out. 2 4 Install the new bulbs in reverse order from the steps above. Be sure that the spring clip is not damaged or detached from the headlamp assembly during the replacement procedure. Replacing HID Headlamp Bulbs (If Equipped) ( 1. 2. 3. 4. Remove the headlamp. Remove service cap. Disconnect the electrical connector. Remove bulb from the headlamp assembly by turning it counterclockwise, then pull it straight out. The low beam headlamps on your vehicle use a high intensity discharge source. These lamps operate at a high voltage. When the bulb is burned out, the bulb and starter capsule assembly must be replaced by your authorized dealer. Low beam headlamp: 236 Escape (TM2)