2013 Ford F150 Super Cab Owner Manual Printing 3 - Page 184

Universal Garage Door Opener (If Equipped) 183 Fixed Code Programming Note: It may be helpful to have another person assist you in programming the transmitter. To program units with fixed code DIP switches, you will need the garage door hand-held transmitter, paper and a pen or pencil. 1. Switch the ignition on. 2. Open the battery cover and note all the switch settings from left to right. When the switch is in the up, on, or + position, mark down "left button". When the switch is in the middle, neutral, or 0 position, mark down "middle button". When the switch is in the down, off, or - position, mark down "right button". 3. Press all three function buttons simultaneously for a few seconds and then release. The LED lamps will flash slowly. Note: The following step must be completed within 2.5 minutes. 4. Enter the corresponding DIP switch settings from left to right into the system by pressing and releasing the buttons corresponding to the settings you noted. 5. Simultaneously press and release all three function buttons. The LED lamps will illuminate. 2013 F-150 (f12) Owners Guide gf, 3rd Printing, February 2013 USA (fus)