2013 Ford F150 Super Cab Owner Manual Printing 3 - Page 81

80 Locks Programming Memory to a Personal Entry Code To program a personal entry code to recall memory settings, repeat Steps 1-4 above. • Pressing 1•2 on the keypad in Step 4 will program the code to driver memory setting 1. • Pressing 3•4 in Step 4 will program the code to driver memory setting 2. Note: Pressing 5•6, 7•8, or 9•0 keypad numbers in Step 4 will not program the code to recall a driver memory setting. Note: The factory-set code cannot be associated with a memory setting. You may also program a personal entry code through the MyFord Touch / MyLincoln Touch system. Refer to the MyFord Touch / MyLincoln Touch chapter. Erasing a Personal Code 1. Enter the factory-set 5-digit code. 2. Press and release the 1•2 on the keypad within five seconds. 3. Press and hold the 1•2 for two seconds. This must be done within five seconds of completing Step 2. All personal codes are now erased and only the factory-set 5-digit code will work. Anti-Scan Feature The keypad will go into an anti-scan mode if you enter the wrong code seven times (35 consecutive button presses). This mode disables the keypad for one minute and the keypad lamp will flash. The anti-scan feature will turn off after: • one minute of keypad inactivity • pressing the unlock button on the remote control • the ignition is turned on. 2013 F-150 (f12) Owners Guide gf, 3rd Printing, February 2013 USA (fus)