2014 Ford Fusion Owner Manual Printing 1 - Page 74

Lighting The system switches the low beam headlamps on at a reduced intensity in daylight conditions. To switch the system on, switch the ignition on, and switch the lighting control to the off, autolamp or parking lamp position. Note: Modification of the vehicle ride height such as using much larger tires, may degrade feature performance. A camera sensor, centrally mounted behind the windshield of your vehicle, continuously monitors conditions to decide when to switch the high beams off and on. Once the system is active, the high beams will switch on if: • the ambient light level is low enough • there is no traffic in front of the vehicle • the vehicle speed is greater than 25 mph (40 km/h) The high beams will switch off if: • the system detects the headlamps of an approaching vehicle or the tail lamps of a preceding vehicle. • vehicle speed falls below 16 mph (25 km/h) • the ambient light level is high enough that high beams are not required • the system detects severe rain, snow or fog • the camera is blocked AUTOMATIC HIGH BEAM CONTROL (IF EQUIPPED) The system will automatically turn on your high beams if it is dark enough and no other traffic is present. When it detects the headlights of an approaching vehicle, the tail lamps of the preceding vehicle or street lighting, the system will turn off the high beams before they distract other drivers. The low beams remain on. Note: If it appears that automatic control of the high beams is not functioning properly, check the windshield in front of the camera for a blockage. A clear view of the road is required for proper system operation. Have any windshield damage in the area of the camera's field-of-view repaired. Note: If the system detects a blockage such as bird droppings, bug splatter, snow or ice, and you do not observe changes, the system will go into low beam mode until you clear the blockage. A message may also appear in the instrument cluster display noting the front camera is blocked. Note: Typical road dust, dirt and water spots will not affect the performance of the automatic high beam system . However, in cold or inclement weather conditions, you will notice a decrease in the availability of the high beam system, especially at start up. If you want to change the beam state independently of the system, you may switch the high beams on or off using the multifunction switch. Automatic control will resume when conditions are correct. Activating the System Switch on the system using the information display and autolamps. See Information Displays (page 85). See Autolamps (page 69). E142451 71