2007 Honda Fit Owner's Manual - Page 110
2007 Honda Fit Manual
Page 110 highlights
Playing the AM/FM Radio To Play the AM/FM Radio The ignition switch must be in the ACCESSORY (I) or ON (II) position. Turn the system on by pushing the PWR/VOL knob or the AM/FM button (AM or FM button except Sport model). Adjust the volume by turning the same knob. The band and frequency that the radio was last tuned to is displayed. To change bands, press the AM/FM button (AM or FM button). On the FM band, ST will be displayed if the station is broadcasting in stereo. Stereo reproduction in AM is not available. To Select a Station You can use any of five methods to find radio stations on the selected band: tune, seek, scan, the preset buttons, and auto select. TUNE Use the TUNE bar to tune to a desired frequency. Press the side of the bar to tune to a higher frequency, and the side to tune to a lower frequency. The seek function SEEK searches up and down from the current frequency to find a station with a strong signal. To activate it, press the or side of the SEEK bar, then release it. SCAN The scan function samples all stations with strong signals on the selected band. To activate it, press the SCAN button, then release it. You will see SCAN in the display. The system will scan for a station with a strong signal. When it finds one, it will stop and play that station for about 10 seconds. If you do nothing, the system will then scan for the next strong station and play it for 10 seconds. When it plays a station you want to listen to, press the SCAN button again. Each preset button PRESET (1 6) can store one station on AM, and two stations on FM. 1. Select the desired band, AM or FM. FM1 and FM2 let you store twelve stations. 2. Use the tune, seek, or scan function to tune the radio to a desired station. 3. Pick a preset number (1 6), and hold it until you hear a beep. 4. Repeat steps 1 through 3 to store a total of six stations on AM and twelve stations on FM. 106