2007 Honda Fit Owner's Manual - Page 200

Wiper Blades 5. Install the new blade onto the blade assembly: Pull back either end of the blade assembly. Place the side of the blade not labeled ''LOCK'' on the end of the blade assembly, and slide the blade onto the assembly until it is fully installed. 6. Slide the wiper blade assembly onto the wiper arm. Make sure it locks in place. To replace the rear wiper blade: 7. Make sure the blade is completely installed and that its edge is not bunched up. 8. Lower the wiper arm down against the windshield, the passenger's side first, then the driver's side. 1. Raise the wiper arm off the glass. 2. Slide the blade out of the wiper arm. 3. Examine the new wiper blade. If it has no plastic or metal reinforcement along the back edge, remove the metal reinforcement strips from the old wiper blade and install them in the 4. Slide the new blade into the wiper arm. Make sure it is engaged in the slot along its full length. 5. Lower the wiper arm. REINFORCEMENT BLADE slots along the edge of the new blade. 196