2008 Honda Fit Owner's Manual - Page 200
2008 Honda Fit Manual
Page 200 highlights
Main Menu Table Of Contents Lights HOLD-DOWN WIRE BULB ELECTRICAL CONNECTOR 5. Unclip the end of the hold-down wire from its slot. Pivot the wire out of the way, then remove the bulb. 6. Install the new bulb into the hole, making sure the tabs are in their slots. Pivot the hold-down wire back in place, and clip the end into the slot. HOLD-DOWN WIRE RUBBER WEATHER SEAL INSPECTION WINDOW 3. Remove the electrical connector from the bulb by pulling the connector straight back. 4. Remove the rubber weather seal by pulling on the tab. 7. Make sure that the hold-down wire is installed properly and securely. You can check its installation from the inspection window on the headlight assembly. 8. Install the rubber seal over the back of the headlight assembly. Maintenance CONTINUED 2008 Fit 197