2005 Jeep Wrangler Owner's Manual - Page 63

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 63 NOTE: If the driver's door is left open, and the headlights or parking lights are left on, the "High Beam Indicator Light" will flash and a chime will sound. Lights-On Reminder If the headlights or parking lights are on after the ignition is turned off, a chime will sound when the driver's door is opened. Headlight Dimmer Switch Pull the multi-function control lever towards you to switch the headlights to HIGH beam. Pull the mutifunction control lever a second time to switch the headlights to LOW beam. Passing Light You can signal another vehicle with your headlights by lightly pulling the multi-function control lever toward the steering wheel. This will cause the headlights to turn on at high beam and remain on until the lever is released. Front Fog Lights - If Equipped The front fog light switch is in the multi-function control lever. To activate the front fog lights, turn on the parking or low beam headlights and pull out the end of the lever. NOTE: The fog lights will only operate with the parking lights or the headlights on low beam. Selecting high beam headlights will turn off the fog lights. Turn Signals Move the multi-function control lever up or down and the arrows on each side of the instrument cluster flash to show proper operation of the front and rear turn signal lights. You can signal a lane change by moving the lever partially up or down without moving beyond the detent. If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light 3