2010 Jeep Wrangler Owner's Manual - Page 139
2010 Jeep Wrangler Manual
Page 139 highlights
138 UNDERSTANDING THE FEATURES OF YOUR VEHICLE NOTE: • If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb. If an indicator fails to light when the lever is moved, it would suggest that the indicator bulb is defective. High/Low Beam Switch Push the multifunction lever away from you to switch the headlights to high beam. Pull the lever toward you to switch the headlights back to low beam. Flash-To-Pass You can signal another vehicle with your headlights by • A tone will chime if the turn signals are left on for lightly pulling the multifunction lever toward the steermore than 1 mile (2 km). ing wheel. This will turn on the high beam headlights until the lever is released. Lane Change Assist Tap the lever up or down once, without moving beyond Front Fog Lights - If Equipped The front fog light switch is located on the multithe detent, and the turn signal (right or left) will flash function lever. To activate the front fog lights, turn three times then automatically turn off. on the parking or low beam headlights and pull Lights-On Reminder out the end of the lever. If the headlights or parking lights are on after the ignition is turned OFF, a chime will sound when the driver's door NOTE: The fog lights will only operate with the parking is opened. lights or the headlights on low beam. Selecting high beam headlights will turn off the fog lights.