2010 Jeep Wrangler Owner's Manual - Page 335
2010 Jeep Wrangler Manual
Page 335 highlights
334 STARTING AND OPERATING If the engine has been flooded, it may start to run, but not have enough power to continue running when the key is released. If this occurs, continue cranking with the accelerator pedal pushed all the way to the floor. Release the accelerator pedal and the key once the engine is running smoothly. If the engine shows no sign of starting after two 15- second periods of cranking with the accelerator pedal held to the floor, repeat the "Normal Starting" or "Extreme Cold Weather" procedures. Then, turn the ignition switch to the START position and release it as soon as the starter engages. The starter motor will disengage automatically in 10 seconds. Once this occurs, release the accelerator pedal, turn the ignition switch to the LOCK position, wait 10 to 15 seconds, then repeat the "Normal Starting" procedure. CAUTION! To prevent damage to the starter, wait 10 to 15 seconds before trying again. With Tip Start - Automatic Transmission Only After Starting If the engine fails to start after you have followed the The idle speed will automatically decrease as the engine "Normal Starting" or "Extreme Cold Weather" procewarms up. dures, it may be flooded. To clear any excess fuel, push the accelerator pedal all the way to the floor and hold it.