2010 Jeep Wrangler Owner's Manual - Page 383

382 STARTING AND OPERATING gravel, it may be desirable to switch to the "Partial Off" mode by pressing the ESP OFF switch. Once the situation requiring ESP to be switched to the "Partial Off" mode is overcome, turn ESP back on by momentarily pressing the ESP OFF switch. This may be done while the vehicle is in motion. "Compass and Mini-Trip Computer - If Equipped" in "Understanding Your Instrument Panel" for further information. To turn ESP on again, momentarily press the ESP OFF switch. This will restore the normal "ESP On" mode of operation. NOTE: • The ESP system will change to "Partial Off" mode if ESP Off (4H Range Only) the vehicle speed exceeds 40 mph (64 km/h). After the This mode is intended for off-highway or off-road use vehicle speed is reduced below 35 mph (56 km/h), the when ESP stability features could inhibit vehicle maneuESP system will return to "Full Off" mode. verability due to trail conditions. This mode is entered by pressing and holding the ESP OFF switch for five seconds • The "ESP OFF" message will display and the audible when the vehicle is stopped and the engine is running. In chime will sound when the shift lever is placed in the this mode, all ESP and TCS stability features are turned PARK position from any position other than PARK, off except for the "limited slip" feature described in the and then moved out of the PARK position. This will TCS section. After five seconds, a chime will sound, the occur even if the message was previously cleared. "ESP/TCS Indicator Light" will illuminate, and the "ESP OFF message will appear in the odometer. Refer to