2012 Jeep Compass Owner Manual - Page 169

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 167 Reprogramming A Single HomeLink௡ Button Using HomeLinkா To reprogram a channel that has been previously trained, To operate, press and release the programmed follow these steps: HomeLink௡ button. Activation will now occur for the programmed device (i.e., garage door opener, gate opera1. Turn the ignition switch to the ON/RUN position. tor, security system, entry door lock, home/office light2. Press and hold the desired HomeLink௡ button until ing, etc.,). The hand-held transmitter of the device may the indicator light begins to flash after 20 seconds. Do not also be used at any time. release the button. Security 3. Without releasing the button proceed with It is advised to erase all channels before you sell or turn "Canadian/Gate Operator Programming" Step 2 and in your vehicle. follow all remaining steps. To do this, press and hold the two outside buttons for 20 seconds until the red indicator flashes. Note that all channels will be erased. Individual channels cannot be erased. The HomeLink௡ Universal Transceiver is disabled when the Vehicle Security Alarm is active. 3