2012 Jeep Liberty Owner Manual - Page 230
2012 Jeep Liberty Manual
Page 230 highlights
228 UNDERSTANDING YOUR INSTRUMENT PANEL If the vehicle electronics sense that the vehicle is driven NOTE: more than 1 mile (1.6 km) with either turn signal on, a • The "ESC Off Indicator Light" and the "ESC Activation/Malfunction Indicator Light" come on mocontinuous chime will sound to alert you to turn the mentarily each time the ignition switch is turned to signals off. If either indicator flashes at a rapid rate, check ON/RUN. for a defective outside light bulb. 11. Electronic Stability Control (ESC) Activation/ Malfunction Indicator Light - If Equipped The "ESC Activation/Malfunction Indicator Light" in the instrument cluster will come on when the ignition switch is turned to the ON/RUN position. It should go out with the engine running. If the "ESC Activation/Malfunction Indicator Light" comes on continuously with the engine running, a malfunction has been detected in the ESC system. If this light remains on after several ignition cycles, and the vehicle has been driven several miles (kilometers) at speeds greater than 30 mph (48 km/h), see your authorized dealer as soon as possible to have the problem diagnosed and corrected. • Each time the ignition is turned to ON/RUN, the ESC system will be ON, even if it was turned off previously. • The ESC system will make buzzing or clicking sounds when it is active. This is normal; the sounds will stop when ESC becomes inactive following the maneuver that caused the ESC activation. 12. Charging System Light This light shows the status of the electrical charging system. The light should come on when the ignition switch is first turned to ON/RUN and remain on briefly as a bulb check. If the light stays on or comes on while driving, turn off some of the vehicle's non-essential electrical devices or increase engine speed (if at idle). If