2013 Jeep Grand Cherokee Owner Manual SRT - Page 194

192 UNDERSTANDING THE FEATURES OF YOUR VEHICLE rear stop. The seat will return to its previously set Each stored memory setting will have an associated Easy position when you place the ignition into the ACC or Entry and Easy Exit position. RUN position. NOTE: The Easy Entry/Exit feature is not enabled when • When you remove the Key Fob from the ignition (or the vehicle is delivered from the factory. The Easy change the ignition to OFF, for vehicles equipped with Entry/Exit feature is enabled (or later disabled) through Keyless Enter-N-Go), the driver seat will move to a the programmable features in the Electronic Vehicle position 0.3 in (7.7 mm) forward of the rear stop if the Information Center (EVIC). Refer to "Electronic Vehicle driver seat position is between 0.9 in and 2.7 in Information Center (EVIC)/Customer-Programmable (22.7 mm and 67.7 mm) forward of the rear stop. The Features" in "Understanding Your Instrument Panel" for seat will return to its previously set position when you further information. place the ignition to the ACC or RUN position. TO OPEN AND CLOSE THE HOOD • The Easy Entry/Easy Exit feature is disabled when the driver seat position is less than 0.9 in (22.7 mm) To open the hood, two latches must be released. forward of the rear stop. At this position, there is no 1. Pull the release lever located below the instrument benefit to the driver by moving the seat for Easy Exit panel and in front of the driver's door. or Easy Entry.