2013 Jeep Grand Cherokee Owner Manual SRT - Page 329

UNDERSTANDING YOUR INSTRUMENT PANEL 327 Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN position or cycle the ignition to the ON/RUN position if equipped with Keyless Enter-N-Go™. To turn off the message temporarily, press and release the MENU button. To reset the oil change indicator system (after performing the scheduled maintenance) refer to the following procedure. Vehicles Not Equipped With Keyless Enter-N-Go™ 1. Turn the ignition switch to the ON/RUN position (Do not start the engine). 2. Fully depress the accelerator pedal, slowly, three times within 10 seconds. 3. Turn the ignition switch to the OFF/LOCK position. NOTE: If the indicator message illuminates when you Vehicles Equipped With Keyless Enter-N-Go™ start the vehicle, the oil change indicator system did not 1. Without pressing the brake pedal, push the ENGINE reset. If necessary, repeat this procedure. START/STOP button and cycle the ignition to the Fuel Economy ON/ RUN position (Do not start the engine). Press and release the UP or DOWN button until "Fuel 2. Fully depress the accelerator pedal, slowly, three times Economy" displays highlighted in the EVIC and press within 10 seconds. the SELECT button. Press and release the UP/DOWN 3. Without pressing the brake pedal, push the ENGINE buttons until one of the following Fuel Economy funcSTART/STOP button once to return the ignition to the tions displays in the EVIC: OFF/LOCK position. • Average Fuel Economy/Fuel Saver Mode 4