2014 Jeep Grand Cherokee Owner Manual - Page 172

170 UNDERSTANDING THE FEATURES OF YOUR VEHICLE To Activate 1. Enable the Automatic High Beams through the Uconnect® system screen. Refer to "Customer- Daytime Running Lights - If Equipped Programmable Features - Uconnect® Access 8.4 The Daytime Running Lights (low intensity) come on Settings" in "Understanding Your Instrument Panel" whenever the engine is running, and the transmission is for further information. not in the PARK position. The lights will remain on until 2. Turn the headlight switch to the AUTO headlight the ignition is switched to the OFF or ACC position or the position. parking brake is engaged. 3. Push the multifunction lever away from you (toward NOTE: If a turn signal is activated, the DRL lamp on the front of vehicle) to engage the high beam mode. same side of the vehicle will turn off for the duration of the turn signal activation. Once the turn signal is no NOTE: This system will not activate until the vehicle is longer active, the DRL lamp will illuminate. at or above 20 mph (32 km/h). The headlight switch must be used for normal nighttime To Deactivate driving. 1. Pull the multifunction lever toward you (or rearward in car) to manually deactivate the system (normal operation of low beams). 2. Push back on the multifunction lever once again to reactivate the system.