2014 Jeep Grand Cherokee Owner Manual - Page 353

UNDERSTANDING YOUR INSTRUMENT PANEL 351 image of the rear surroundings of your vehicle whenever the shift lever is put into REVERSE. The image will be displayed on the radio touchscreen display along with a caution note to "check entire surroundings" across the top of the screen. After five seconds, this note will disappear. The ParkView® camera is located on the rear of the vehicle above the rear License plate. To make your selection, touch the "ParkView Backup Camera" soft-key, until a check-mark appears next to setting, indicating that the setting had been selected. Touch the back arrow NOTE: If your vehicle has experienced any damage in soft-key to return to the previous menu. the area where the sensor is located, even if the fascia is not damaged, the sensor may have become misaligned. • ParkView® Backup Camera Active Guidelines Take your vehicle to an authorized dealer to verify sensor Your vehicle may be equipped with the ParkView® Rear alignment. Having a sensor that is misaligned will result Back Up Camera Active Guidelines that allows you to see in the BSM not operating to specification. active guidelines over the ParkView Back up camera diswill only show a visual alert in the exterior mirrors. When "Lights & Chime" mode is activated, the Blind Spot Monitor (BSM) will show a visual alert in the exterior mirrors as well as an audible alert when the turn signal is on. When "Off" is selected, the Blind Spot Monitor (BSM) system is deactivated. To change the Blind Spot Alert status, touch the "Off," "Lights" or "Lights & Chime" soft-key. Then touch the back arrow soft-key. • ParkView® Backup Camera play whenever the shift lever is put into REVERSE. The image will be displayed on the radio touchscreen display Your vehicle may be equipped with the ParkView® Rear along with a caution note to "check entire surroundings" Back Up Camera that allows you to see an on-screen across the top of the screen. After five seconds, this note will 4