2014 Jeep Grand Cherokee Owner Manual - Page 544

542 STARTING AND OPERATING 7. When the "N" indicator light turns off, release the "N" NOTE: button. After the "N" button has been released, the • Steps 1 through 5 are requirements that must be met transfer case will shift to the position indicated by the prior to pressing the "N" button, and must continue to selector switch. be met until the shift has been completed. If any of 8. Shift the transmission into PARK. Turn the engine these requirements are not met prior to pressing the OFF. "N" button or are no longer met during the shift, the "N" indicator light will flash continuously until all 9. Release the brake pedal. requirements are met or until the "N" button is re10. Disconnect vehicle from the tow vehicle. leased. 11. Start the engine. 12. Press and hold the brake pedal. 13. Release the parking brake. • The ignition switch must be in the ON/RUN position for a shift to take place and for the position indicator lights to be operable. If the ignition switch is not in the ON/RUN position, the shift will not take place and no position indicator lights will be on or flashing. 14. Shift the transmission into DRIVE, release the brake pedal, and check that the vehicle operates normally. • A flashing "N" position indicator light indicates that shift requirements have not been met.