2014 Jeep Grand Cherokee Owner Manual SRT - Page 261

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 259 If you unplugged the garage door opener/device for Using HomeLink® programming, plug it back in at this time. To operate, press and release the programmed HomeLink® button. Activation will now occur for the programmed Reprogramming A Single HomeLink® Button device (i.e., garage door opener, gate operator, security To reprogram a channel that has been previously trained, system, entry door lock, home/office lighting, etc.,). The follow these steps: hand-held transmitter of the device may also be used at 1. Cycle the ignition to the ON/RUN position. any time. 2. Press and hold the desired HomeLink® button until Security the indicator light begins to flash after 20 seconds. Do It is advised to erase all channels before you sell or turn not release the button. in your vehicle. 3. Without releasing the button proceed with To do this, press and hold the two outside buttons for 20 "Canadian/Gate Operator Programming" step 2 and seconds until the red indicator flashes. Note that all follow all remaining steps. channels will be erased. Individual channels cannot be erased. The HomeLink® Universal Transceiver is disabled when the Vehicle Security Alarm is active. 3