2008 Lincoln Navigator Owner Guide 2nd Printing (Spanish) - Page 476

Lights Replacing fog lamp bulbs 1. From underneath the vehicle, rotate the harness/bulb assembly counterclockwise, to remove from the fog lamp assembly. 2. Carefully disconnect the bulb from the harness assembly via the two snap clips. Install the new bulb in reverse order. Replacing tail/stop/turn/backup lamp bulbs The tail/stop/turn/backup lamp bulbs are located in the same portion of the tail lamp assembly, one just below the other. Follow the same steps to replace either bulb. 1. Make sure the headlamp switch is in the "O"position. 2. Open the liftgate to expose the lamp assembly screws. 3. Remove the two screws from the lamp assembly. 4. Carefully pry the lamp assembly away from the vehicle by pulling the assembly directly straight out to expose the bulb socket. DO NOT TIP THE LAMP ASSEMBLY SIDEWAYS. 5. Rotate the bulb socket counterclockwise and remove from lamp assembly. 6. Pull bulb straight out of the socket and push in the new bulb. 7. Install the bulb socket into the lamp assembly and rotate clockwise. 8. Install the lamp assembly on the vehicle and secure with two screws. Replacing supplemental tail lamp bulbs 1. Make sure the headlamp switch is in the "O" position. 2. Open the liftgate and remove interior trim panel. 80 2008 Navigator (nav) Owners Guide (post-2002-fmt) USA (fus)