2015 Lincoln MKS Owner Manual Printing 1 - Page 63
2015 Lincoln MKS Manual
Page 63 highlights
Locks Note: Pressing 5·6, 7·8, or 9·0 keypad numbers as a sixth digit will not recall a driver memory setting. Note: The factory-set code cannot be associated with a memory setting. You may also program a personal entry code through the MyLincoln Touch system. See Settings (page 313). Tips: • Do not set a code that uses five of the same number. • Do not use five numbers in sequential order. • The factory-set code will work even if you have set your own personal code. Erasing a Personal Code 1. Enter the factory-set 5-digit code. 2. Press and release 1·2 on the keypad within five seconds. 3. Press and hold 1·2 for two seconds. You must do this within five seconds of completing Step 2. All personal codes are now erased and only the factory-set 5-digit code will work. Anti-Scan Feature The keypad will go into an anti-scan mode if you enter the wrong code seven times (35 consecutive button presses). This mode disables the keypad for one minute and the keypad lamp will flash. The anti-scan feature will turn off after: • One minute of keypad inactivity. • Pressing the unlock button on the remote control. • Switching the ignition on. • Unlocking your vehicle using intelligent access. Unlocking and Locking the Doors To Unlock the Driver Door Enter the factory-set 5-digit code or your personal code. You must press each number within five seconds of each other. The interior lamps will illuminate. Note: All doors will unlock if you disable the two-stage unlocking feature. See Locking and Unlocking (page 56). To Unlock All Doors Enter the factory-set code or your personal code, then press 3·4 within five seconds. To Lock All Doors Press and hold 7·8 and 9·0 at the same time (with the driver door closed). You do not need to enter the keypad code first. Displaying the Factory Set Code Note: You will need to have two programmed intelligent access keys for this procedure. To display the factory-set code in the information display: E173591 1. Place the first programmed key in the backup slot beneath the glovebox door. The key ring must be at the top with the buttons facing toward the rear. 2. Press the START/STOP button once and wait a few seconds. 60 MKS (), enUSA