2015 Lincoln MKS Owner Manual Printing 1 - Page 67

Security Make sure that your vehicle is off before beginning this procedure. Make sure that you close all the doors before beginning and that they remain closed throughout the procedure. Perform all steps within 30 seconds of starting the sequence. Stop and wait for at least one minute before starting again if you perform any steps out of sequence. Read and understand the entire procedure before you begin. 4. Within 10 seconds, place a second programmed intelligent access key in the backup slot. Press the push button ignition switch. 5. Wait five seconds and then press the push button ignition switch again. 6. Remove the intelligent access key. 7. Place the unprogrammed intelligent access key in the backup slot and press the push button ignition switch. Programming is now complete. Verify the remote control functions operate and your vehicle starts with the new intelligent access key. If programming was not successful, wait 10 seconds and repeat Steps 1 through 7. If you are still unsuccessful, take your vehicle to your authorized dealer. E173591 Take all remote controls to an authorized dealer if there is any potential alarm problem with your vehicle. Arming the Alarm The alarm is ready to arm when there is not a key in the ignition. Electronically lock the vehicle to arm the alarm. Disarming the Alarm To disarm the alarm do any of the following Press the power door unlock button within the 20-second pre-arm period. Unlock the doors with the keyless entry pad. Press the unlock button on the remote control. Enter the vehicle using intelligent access. Press the panic button on the remote control. The alarm system remains armed, but the horn and turn indicators shut off. ANTI-THEFT ALARM (If Equipped) The system will warn you of an unauthorized entry to your vehicle. Anyone opening any door, the luggage compartment or the hood without using a valid key, remote control or keyless entry keypad will set off the alarm. The turn signal lamps will flash and sound the horn up to a total of 10 times. 1. Place the first programmed key in the backup slot beneath the glovebox door, then press the push button ignition switch. 2. Wait five seconds and then press the push button ignition switch again. 3. Remove the intelligent access key. Note: If the driver door is unlocked with a key, a tone will sound when you open the door and a message will appear in the information display. You will have 12 seconds to disarm the alarm using any of the actions above, otherwise the alarm goes off. 64 MKS (), enUSA