2008 Mazda CX-9 Owner's Manual - Page 580
2008 Mazda CX-9 Manual
Page 580 highlights
n Tuning The radio has the following tuning methods: Manual, Seek, Scan, Preset channel, and Auto memory tuning. The easiest way to tune stations is to set them on preset channels. Note lIf the FM broadcast signal becomes weak, reception automatically changes from STEREO to MONO for reduced noise, and the STEREO indicator will go out. lTo clear the information, press the NAVI button. lIf the power supply is interrupted (fuse blows or the battery is disconnected), the preset channels will be canceled. n Manual Before Use Getting started 74 Routing Address Book Voice Navigation RDM-TMC Recognition Set Up tuning Pressing the seek tuning button will change the frequency higher or lower. n Seek tuning , ) will cause the tuner to seek a higher Pressing and holding the seek tuning button ( or lower frequency automatically. Note If you continue to press and hold the button, the frequency will continue changing without stopping. n Scan tuning Press the (SCAN) button to automatically sample strong stations. Scanning stops at each station for about 5 seconds. To hold a station, press the (SCAN) button again during this interval. n Preset channel tuning Audio Operation Navigation Set Up The 8 preset channels can be used to store 8 AM and 16 FM stations. 1. To set a channel first select AM, FM1, or FM2. Tune to the desired station. 2.Select any channel preset on-screen button for about 2 seconds until a beep sound is heard. The selected preset channel number and station frequency will be displayed. The station is now held in the memory. 3.Repeat this operation for the other stations and bands you want to store. To tune one in the memory, select AM, FM1, or FM2 and then press its channel preset button. The station frequency and the channel number will be displayed. Note If the power supply is interrupted (fuse blows or the battery is disconnected), the preset channels will be canceled.