2006 Mercedes E-Class Owner's Manual - Page 296
2006 Mercedes E-Class Manual
Page 296 highlights
Controls in detail Useful features Step 2: If you have previously programmed an signal transmitter button and wish to retain its programming, proceed to step 3. If you are programming the integrated remote control for the first time, press and hold the two outer signal transmitter buttons 2 and 4 and release them only when the indicator lamp 1 begins to flash after approximately 20 seconds (do not hold the button for longer than 30 seconds). This procedure erases any previous settings for all three channels and initializes the memory. If you later wish to program a second and/or third hand-held transmitter to the remaining two signal transmitter buttons, do not repeat this step and begin directly with step 3. Step 3: Hold the end of the hand-held remote control 5 of the device you wish to train approximately 2 to 5 in (5 to 12 cm) away from the signal transmitter button (2, 3 or 4) to be programmed, while keeping the indicator lamp 1 in view. Step 4: Using both hands, simultaneously press the hand-held remote control button 6 and the desired signal transmitter button (2, 3 or 4). Do not release the buttons until step 5 is completed. The indicator lamp 1 will flash, first slowly and then rapidly. i The indicator lamp 1 flashes immediately the first time the signal transmitter button is programmed. If this button has already been programmed, the indicator lamp will only start flashing after 20 seconds. Step 5: After the indicator lamp 1 changes from a slow to a rapidly flashing light, release the hand-held remote control button and the signal transmitter button. Step 6: Press and hold the just-trained signal transmitter button (2, 3 or 4) and observe the indicator lamp 1. 295