2006 Mercedes E-Class Owner's Manual - Page 298
2006 Mercedes E-Class Manual
Page 298 highlights
Controls in detail Useful features i Some garage door openers (or other rolling code equipped devices) may require you to press, hold for 2 seconds and release the same signal transmitter button a third time to complete the training process. Step 12: Confirm the garage door operation by pressing the programmed signal transmitter button (2, 3 or 4). Step 13: To program the remaining two signal transmitter buttons, repeat the steps above starting with step 3. Gate operator/Canadian programming Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of transmission which may not be long enough for the integrated signal transmitter to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are designed to "time-out" in the same manner. If you live in Canada or if you are having difficulties programming a gate operator (regardless of where you live) by using the programming procedures, replace step 4 with the following: Step 4: Press and hold the signal transmitter button (2, 3 or 4). Do not release this button until it has been successfully trained. While still holding down the signal transmitter button (2, 3 or 4), "cycle" your hand-held remote control button 6 as follows: Press and hold button 6 for 2 seconds, then release it for 2 seconds, and again press and hold it for 2 seconds. Repeat this sequence on the hand-held remote control until the frequency signal has been learned. Upon successful training, the indicator lamp 1 will flash slowly and then rapidly after several seconds. Proceed with programming step 5 and step 6 to complete. 297