2009 Mercedes CLS-Class Owner's Manual - Page 142
2009 Mercedes CLS-Class Manual
Page 142 highlights
Controls in detail Control system Distance to empty X Telephone menu G Warning! A driver's attention to the road must always be his/her primary focus when driving. For your safety and the safety of others, we recommend that you pull over to a safe location and stop before placing or taking a telephone call. If you choose to use the telephone while driving, please use the hands-free device and only use the telephone when weather, road and traffic conditions permit. Some jurisdictions prohibit the driver from using a mobile phone while driving a vehicle. Bear in mind that at a speed of just 30 mph (approximately 50 km/h), your vehicle is covering a distance of 44 feet (approximately 14 m) every second. Never operate radio transmitters equipped with a built-in or attached antenna (i.e. without being connected to an external antenna) from inside the vehicle while the engine is running. Doing so could lead to a malfunction of the vehicle's electronic system, possibly resulting in an accident and/ or personal injury. Press button ÿ or è repeatedly until the first function of the Trip computer menu appears in the multifunction display. Press button j or k repeatedly until the message Range: appears in the multifunction display. The calculated remaining driving range based on the current fuel tank level appears in the multifunction display. If only very little fuel is left in the tank, a vehicle at the fuel pump ¿ is shown instead of the range. X You can connect your telephone via Bluetooth® to the COMAND system, see separate COMAND system operating instructions. X Switch on the COMAND system. See separate COMAND system operating instructions. X Press button ÿ or è on the multifunction steering wheel repeatedly until the message TEL appears in the multifunction display. One of the following messages will appear in the multifunction display: RNo Service: No network is available. RBluetooth Ready: The telephone has not been connected to the COMAND system via Bluetooth® yet. X Connect the telephone to the COMAND system via Bluetooth®. RReady or name of the network provider (if available): The telephone has found a network and is ready for use. You can operate it using the control system. 140