2010 Mercedes CLS-Class Owner's Manual - Page 104
2010 Mercedes CLS-Class Manual
Page 104 highlights
219_AKB; 4; 54, en-US d2ureepe, 2009-05-11T16:21:02+02:00 - Seite 102 Version: 2.11.8.1 102 Automatic transmission carpets in the footwell, make sure the pedals still have sufficient clearance. During sudden driving or braking maneuvers the objects could get caught between or under the pedals. You could then no longer brake or accelerate. This could lead to accidents and injury. Controls in detail ! Allow the engine to warm up under low load use. Do not place full load on the engine until the operating temperature has been reached. Avoid spinning of a drive wheel for an extended period when driving off on slippery road surfaces. This may cause serious damage to the engine and the drivetrain which is not covered by the Mercedes-Benz Limited Warranty. i During the brief warm-up, transmission upshifting is delayed. This allows the catalytic converter to heat up more quickly to operating temperature. Gear selector lever G Warning! It is dangerous to shift the automatic transmission out of park position P or neutral position N if the engine speed is higher than idle speed. If your foot is not firmly on the brake pedal, the vehicle could accelerate quickly forward or in reverse. You could lose control of the vehicle and hit someone or something. Only shift into gear when the engine is idling normally and when your right foot is firmly on the brake pedal. ! Only shift the automatic transmission into reverse gear R or park position P when the vehicle is stopped. Otherwise the automatic transmission could be damaged. i Shifting the automatic transmission out of park position P is only possible with the brake pedal depressed. Only depressing the brake pedal releases the gear selector lever lock. i The current gear selector lever position corresponds with the current transmission position. The current transmission position P, R, N, or D appears in the multifunction display (Y page 103). There are additional indicators on the cover of the shifting gate showing the current gear selector lever position. The indicators come on when you insert the SmartKey into the starter switch, and go out when you remove the SmartKey from the starter switch. Shifting procedure The automatic transmission selects individual gears automatically, depending on Rthe selected gear range (Y page 104) Rthe Gearshift pattern for automatic transmission j Park position with gear selector lever lock k Reverse gear i Neutral position h Drive position selected program mode: C/S (Y page 105) or