2011 Mercedes GL-Class Owner's Manual - Page 293
2011 Mercedes GL-Class Manual
Page 293 highlights
Features from the transmitter button that you are programming. Try different angles from a distance of 2 to 12 inches (5 to 30 cm) or the same angle from differing distances. RIf there is another garage door remote control for the same device, perform the programming steps again using the remote control. Before performing these steps, make sure that new batteries have been installed in the garage door remote control. RAlign the antenna cable of the garage door opener unit. This can improve signal reception/transmission. 291 Clearing the remote control memory X i You should clear the remote control memory before selling the vehicle. Compass X Opening or closing the garage door Once programmed, the integrated remote control will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system. X Turn the SmartKey to position 2 in the ignition lock. X Press transmitter button ;, = or ? in the overhead control panel that you have programmed to operate the garage door. Garage door system with fixed code: indicator lamp : lights up continuously. Garage door system with rolling code: indicator lamp : flashes briefly and then lights up for approximately two seconds. This is repeated for up to 20 seconds. i The transmitter will transmit a signal for as long as the transmitter button is being pressed. The transmission will be halted after a maximum of 20 seconds and indicator lamp : will flash. Press the transmitter button again, if necessary. To call up the compass: press the V or U button on the multifunction steering wheel repeatedly until the off-road menu appears in the multifunction display. The compass indicates the direction in which the vehicle is currently driving: N, NE, E, SE, S, SW, W or NW. i If your vehicle is not equipped with the AIRMATIC package, the multifunction display only shows the compass. Floormat on the driver's side G Warning! Whenever you are using a floormat, make sure there is enough clearance and that the floormat is securely fastened. The floormat should always be securely fastened using the fastening equipment. Before driving off, check that the floormat is securely in place and adjust it if necessary. A loose floormat could slip and hinder proper functioning of the pedals. Z Loading, stowing and features Turn the SmartKey to position 2 in the ignition lock. X Press and hold transmitter buttons ; and ? for approximately 20 seconds until indicator lamp : flashes rapidly. The memory is cleared.