2011 Mercedes GL-Class Owner's Manual - Page 92
2011 Mercedes GL-Class Manual
Page 92 highlights
90 Sliding sunroof X X Opening and closing Overhead control panel : To raise ; To open = To close X X Reinsert the fuse. Switch on the ignition. X Raise the tilt/sliding sunroof fully at the rear (Y page 89). X Keep the 2 switch pressed for another second. X Make sure that the tilt/sliding sunroof can be opened or closed fully again using the opening/closing process (Y page 89). X If the tilt/sliding sunroof can be raised fully at the rear it is set correctly. If this is not the case, you must repeat the previously described steps. Switch on the ignition. Push or pull the 2 switch in the corresponding direction. i If you press the 2 switch beyond the point of resistance, an automatic opening/ closing process is started in the corresponding direction. You can stop automatic operation by pressing again. Automatic opening/raising is only available if the tilt/sliding sunroof is in the closed position. You can open/close the cover for the sunblind manually when the tilt/sliding sunroof is raised/closed. Problems with the sliding sunroof Problem: the sunroof cannot be closed and you cannot see the cause. G Warning! You could be severely or even fatally injured when closing the sliding sunroof with increased closing force or if the antientrapment feature is deactivated. Make sure that nobody can become trapped when closing the sliding sunroof. If the sliding sunroof is obstructed during closing: X Resetting Reset the tilt/sliding sunroof if it does not open smoothly, or if the battery has been disconnected or has become discharged. ! Contact a qualified specialist workshop if the tilt/sliding sunroof cannot be closed fully or reset. X Immediately after the sliding sunroof blocks, pull the 2 switch in the overhead control panel down to the point of resistance and hold it until the sliding sunroof is closed. The sliding sunroof is closed with increased force. Remove the SmartKey from the ignition lock or turn to position 0 (KEYLESS-GO). X Remove the fuse for the tilt/sliding sunroof from the main fuse box. To find out where the fuse is located, refer to the fuse allocation chart in the vehicle tool kit (Y page 310). If the sliding sunroof is obstructed during closing again: X Immediately after the sliding sunroof blocks, pull the 2 switch in the overhead control panel down to the point of resistance and hold it until the sliding sunroof is closed. The sliding sunroof is closed without the anti-entrapment feature.