2003 Nissan Pathfinder Owner's Manual - Page 70
2003 Nissan Pathfinder Manual
Page 70 highlights
dealer. You do not need to have your vehicle towed to the dealer. ¼ Malfunction indicator lamp blinking - An engine misfire has been detected which may damage the emission control system. To reduce or avoid emission control system damage: * do not drive at speeds above 45 MPH (72 km/h). * avoid hard acceleration or deceleration. * avoid steep uphill grades. * if possible, reduce the amount of cargo being hauled or towed. The malfunction indicator lamp may stop blinking and come on steady. Have the vehicle inspected by an authorized NISSAN dealer. You do not need to have your vehicle towed to the dealer. the emission control system. Slip indicator light (if so equipped) This indicator will blink when the VDC system is operating, thus alerting the driver to the fact that the road surface is slippery and the vehicle is nearing its traction limits. Overdrive off indicator light (Automatic transmission models only) This light comes on during driving when the overdrive switch is pressed to prevent overdrive operation. The O/D OFF indicator light comes on for two seconds each time the ignition key is turned ON. This shows the light is functioning properly. If the O/D OFF indicator light blinks for approximately 8 seconds after coming on for 2 seconds, have your NISSAN dealer check the transmission and repair it if necessary. The automatic transmission is equipped with an electronic Fail-Safe mode. This system allows the vehicle to be driven even in the event of damage to the electrical circuits. If this occurs, the gears automatically engage and lock into 3rd gear. See "Driving the vehicle" in the "5. Starting and driving" section for failsafe before visiting your NISSAN dealer. Transfer 4LO position indicator model) light ( The light should turn off within 1 second after turning the ignition switch to ON. This light comes on when the 4WD shift switch is set in the 4LO position with ignition key in the ON position. If the 4WD shift switch is set in the 4LO position and the light blinks, stop the vehicle, drive slowly forward and the light will turn on. When you shift between 4H and 4LO, stop the vehicle, move the automatic transmission selector lever to the N position, and press the 4WD shift switch and move it in 4LO or 4H. The transfer case may be damaged if you shift the switch while driving. You cannot move the transfer 4WD shift switch between 4H and 4LO unless you have first stopped the vehicle and moved the automatic transmission shift lever to neutral. Make sure the Instruments and controls CAUTION Continued vehicle operation without having the emission control system checked and repaired as necessary could lead to poor driveability, reduced fuel economy, and possible damage to 2-15