2003 Nissan Pathfinder Owner's Manual - Page 99

HomeLink UNIVERSAL TRANSCEIVER (if so equipped) The HomeLink Universal Transceiver provides a convenient way to consolidate the functions of up to three individual hand-held transmitters into one built-in device. The HomeLink Universal Transceiver power will automatically turn off 30 minutes after the ignition switch has been turned to the off position. HomeLink Universal Transceiver: ¼ Will operate most Radio Frequency (RF) devices such as garage doors, gates, home and office lighting, entry door locks and security systems. ¼ Is powered by your vehicle's battery. No separate batteries are required. If the vehicle's battery is discharged or is disconnected, HomeLink will retain all programming. Once the HomeLink Universal Transceiver is programmed, retain the original transmitter for future programming procedures (i.e., new vehicle purchases). Upon sale of the vehicle, the programmed HomeLink Universal Transceiver buttons should be erased for security purposes. For additional information, refer to "Programming HomeLink " later in this section. WARNING ¼ Do not use the HomeLink Universal Transceiver with any garage door opener that lacks safety stop and reverse features as required by federal safety standards. (These standards became effective for opener models manufactured after April 1, 1982). A garage door opener which cannot detect an object in the path of a closing garage door and then automatically stop and reverse, does not meet current federal safety standards. Using a garage door opener without these features increases the risk of serious injury or death. ¼ During programming, your garage door or gate may open or close. Make sure that people and objects are clear of the garage door or gate that you are programming. ¼ Your vehicle's engine should be turned off while programming the HomeLink Universal Transceiver. PROGRAMMING HomeLink To program your HomeLink Transceiver to operate a garage door, gate, or entry door opener, home or office lighting, you need to be at the same location as the device. Note: Garage door openers (manufactured after 1996) have "rolling code protection". To program a garage door opener equipped with "rolling code protection"; you will need to use a ladder to get up to the garage door opener motor to be able to access the "smart or learn" program button. 2-44 Instruments and controls