2004 Nissan Murano Owner's Manual - Page 120

while the selector lever is in the P (Park) position. The entry/exit feature can be adjusted or canceled. See "Display screen, heater, air conditioner and audio systems" section of this manual. and supplemental air bags" section and "Pedal position adjustment" and "Outside mirrors" earlier in this section. During this step, do not turn the ignition to any positions other than ON. 4. Push the SET switch and, within 5 seconds, push the memory switch (1 or 2) fully for at least 1 second. The indicator light for the pushed memory switch will come on and stay on for approximately 5 seconds after pushing the switch. After the indicator light goes off, the selected positions are stored in the selected memory (1 or 2). If memory is stored in the same memory switch, the previous memory will be deleted. SPA1584 MEMORY STORAGE Two positions for the driver's seat, pedals (Brake and Accelerator) and outside mirrors can be stored in the automatic drive positioner memory. Follow these procedures to use the memory system. 1. Set the selector lever to the P (Park) position. 2. Turn the ignition ON. 3. Adjust the driver's seat, pedals (Brake and Accelerator) and outside mirrors to the desired positions by manually operating each adjusting switch. For additional information, see "Seats" in the "Safety - Seats, seat belts Linking a keyfob to a stored memory position A keyfob can be linked to a stored memory position with the following procedure. 1. Follow the steps for storing a memory position. 2. While the indicator light for the memory switch being set is illuminated for 5 seconds, press the unlock button on the keyfob. The indicator light will blink. After the indicator Pre-driving checks and adjustments 3-17